To minimize our carbon footprint, installation instructions for Urbafor Solutions products can be found on this page!
Place the first 4 rectangles with 5/8 holes to form a perfect square around and in the middle of the tree.
Use a sledgehammer to press the 4 studs into each hole.
Add the remaining rectangles with the 5/8 holes.
Use a sledgehammer to press the 4 studs into each hole.
Place the segments all around the shaft, including the center stabilizer segments.
Place studs in all holes, including those for the stabilizers. Please position the stabilizers at the desired angle before inserting them into the ground.
Install mulch using the guide on the stabilizers.
Installation of the rodent guard at the base of the tree. Using a small ladder and sledgehammer, drive the stake at least 30 cm into the ground, at a maximum distance of 50 cm from the tree.
Wrap the turnbuckle around the tree and tie the turnbuckle to the stake in a double knot. The tutor must be uninstalled after 2 years.
Urbafor is committed to transparency and informs you of its data collection and retention practices.